FAQ
General
Leber V2, designed by S3igu2, is an MP5 lower housing adapted to carry an AR-15 milspec trigger. Download and print your own housing here if you know the process.
SS is not required for Leber V2, but if you want to build it with SS, you will need:
- Leber V2 housing
- Super Safety kit / pre-cut trigger: (Note: We do not sell the SS kit, but we recommend the DNT D2 kit.)
- MP5 slip trip
Polymaker PA612-CF offers superior performance compared to PLA+ thanks to its high heat resistance, desirable matte finish, strength, and toughness.
Each Leber housing takes 2-4 days to produce. Recognizing that not all Leber housing printing processes are equal, L2Prints prioritizes high quality. Unlike those who rush production, we ensure material is dried for 10 hours at 200°F before a 20-hour print, followed by a 10-hour annealing process at 210°F.
The Leber V2 MP5 housing is a non-serialized part, so it can be shipped directly to your door; no FFL is required.
Troubleshooting
Cut the rear of the detent to allow it to rise freely
